Under Tile Heating
Site Instructions
Wiring Instructions
Warranty
Thermostat
Price
Under Carpet Heating
Hydronic Water System
Ventilation & Moisture Removal
Fujitsu Heat Pumps
Heat-ON Radiant Ceiling Heating
In-Concrete Heating
Heated Towel Rails
Mirror Demisters
Thermostats
Central Vacuuming
 





Under Tile Heating Wiring Instructions
Electrician's Wiring Instructions
  • Mount thermostat flush box vertically, approximately 1500mm above floor level.
  • Install a substantial draw wire (2.5mm conduit wire is ideal). Holes for draw wire must be a minimum of 25mm.
  • Check out bottom plate to a minimum dimension of 50mm wide and 25mm deep and chase a 15mm depression in floor.
  • Wire sub-circuit from distribution board or nearby power circuit that has sufficient spare capacity to carry the extra heating load. Note: The owner will have a list of element loadings from the original quote.
  • All circuits SHOULD BE RCD protected (failure to fit RCD will invalidate warranty).

If you have any enquiries call: 0800HEATING

 

| Home | Under Tile Heating | Under Carpet Heating | Fujitsu Air Conditioners | DIY Set Mats | Mirror Demisters | Radiant Ceiling Heating | In-Concrete Heating | Horticultural Heating |
| Panel Heaters | Radiance Heated Towel Rails | Company Profile | Product History | NZ Dealers | International Dealers | Contact Us |