Mount thermostat flush box Vertically,
approximately 1500mm above floor level.
Install a substantial draw wire (2.5mm conduit
wire is ideal). Holes for draw wire must
be a minimum of 25mm.
Check out bottom plate to a minimum dimension
of 50mm wide and 25mm deep and chase a 15mm
depression in floor.
Wire sub-circuit from distribution board or
nearby power circuit that has sufficient spare
capacity to carry the extra heating load. Note:
The owner will have a list of element loadings
from the original quote.
All circuits SHOULD BE RCD protected
(failure to fit RCD will invalidate warranty).
Under
Tile Heating
Under
Carpet Heating
Hydronic
Water System
Ventilation
& Moisture Removal
Fujitsu
Heat Pumps
Heat-ON
Radiant Ceiling Heating 
In-Concrete
Heating
Heated
Towel Rails
Mirror
Demisters
Thermostats
Central
Vacuuming 
